|   complete IS disk standard? | GMF
Apr 1, 2002 1:14 PM | | I was wondering where the IS standard was completely laid out. Magura seems to have a bit of info, which is helpful (distance from inside of dropout to disk mounting surface), but what about?
1) distance to disk-side hub flange
2) bolt hole pattern
3) etc.
Basically, i could use the complete IS disk spec if anyone has it handy, or knows where one might be floating around the 'net. In particular, i need this info for the rear hub.
Thanks,
-GMF |
| Hayes has drawings too.... | Monte
Apr 1, 2002 1:16 PM | | Pretty complete and dxf if you want it.
Monte |
| |
