|   '01 Jr. T question? | Stinky Monkey
Oct 21, 2001 4:19 PM | | On the upper portion of each stanchion there are 2 lines going around the tube, about 3 1/2" apart. What are these for? Where in relation to these marks should my lower crown be? Above the lower mark? Below the lower mark?
Thanks,
Kevin |
| re: '01 Jr. T question? | Gutty
Oct 21, 2001 6:01 PM | | I believe the two lines should be between you top and bottom triple clamps. So i think the lower crown should be below the lower mark. The top crown should be above the upper mark. Does this sound right/look right when done to the bike |
| re: '01 Jr. T question? | Stinky Monkey
Oct 21, 2001 7:12 PM | | I hope so. That is the way I have them now. I just wanted to make sure. Does anyone know for sure? |
| re: '01 Jr. T question? | Gutty
Oct 22, 2001 12:49 PM | | Well i've had mine setup this way for 12months and have'nt had a problem. Any space between the markings and the crowns is your head angle adjustment.(move the stantions up or down in the clamps) |
| Does anyone know anything about Jrt's? nm | Stinky Monkey
Oct 22, 2001 12:46 PM | | ??????? |
| Yes you are ok | jerkass
Oct 22, 2001 8:32 PM | | Yes the bottom line should be above lower crown. To adjust you can take out springs lower fork to bottom. Adjust your crown so you have 3mm of clearance from tire. This will change if you add a fender. If you would like to make it plush you can drill holes. You can add 8" disk and if you play with the oil hight it is very adjustable. If you change oil use golden spectro 125/150 and use slick honey. |
| |
