|   Rebuild a Z1 MCR | mattofatto
Mar 19, 2003 12:45 PM | | I't time to rebuild my marzocchi z1mcr and I've never rebuilt a fork before. Does anyone have a link to some good instructions. Or, if it's easy, can you tell me what's involved? I have taken them appart before, but I just want to know if there is more ivolved than just changing out the oil. |
| I just did this | Scott P
Mar 19, 2003 1:46 PM | | Besides what you do for the oil. The bushings should still be ok. So take the lowers off & use a large screwdriver to carefully pry the top seals out. Put a tough piece of rubber or somthing under the driver to protect the fulcrum area under the driver. Now the lower seals are a bit harder. Stick the driver under the seal only enough to grab the aluminum ring inside the seal & pry up with a bit of force. To get the new ones in I used a big 1 1/8 socket I think & pounded them down with a hammer. Lube everything & very carefully slide the shafts thru the new seals & reassemble. Maybe check marz site for more info. Good luck |
| |
